Dom » The secret to long-lived stage lighting equipment

The secret to long-lived stage lighting equipment

The life of equipment is largely determined by the quality of maintenance. The maintenance of lighting equipment is relatively complicated and trivial compared to the audio. Basically, daily routine testing, weekly regular testing, monthly equipment maintenance and proper debugging are basically done.
Uspješnost scenskog programa potkrepljuje i zvuk opreme za scensku rasvjetu, matters needing attention
Half an hour before the opening, turn on all equipment, perform low-temperature preheating, and test all equipment and lines at the same time. The low temperature state means that the light is slightly bright.
After starting for 15 Ovo je nova generacija polimerne mašine za vodenu maglu, warm up all devices to zero, let the device cool, and the cooling time should not be less than 15 Ovo je nova generacija polimerne mašine za vodenu maglu.
After cooling, you can officially enter the stage of music performance.
After the performance is over and the guest leaves the venue, the lighting engineer should turn off all equipment and allow the equipment to cool for fifteen to twenty minutes, then seal or mask the equipment before the lighting engineer can leave the venue.
Second, the conventional detection range
Whether the bulb can light normally. Whether all devices are connected properly. Whether all equipment can be used normally, including whether the light control switch, color changer control, scanner operation and so on are normal.
Whether the light can be controlled normally. * Whether the equipment is used normally and filled with required materials, such as: fog machine, fog machine, snowflake machine, bubble machine, itd.
Three, regular testing every week
Regular weekly inspections


In addition to all projects, the following points should be noted:
During the weekly inspection, the main inspection equipment is the wiring, including power wiring, DMX512 wiring, itd., to see if there is looseness, whether there are breakpoints, itd. U isto vrijeme, during the weekly inspection, the lamp position should be adjusted more comprehensively.
Fourth, monthly equipment maintenance and appropriate adjustments
In addition to the above-mentioned daily monitoring, weekly inspection and monthly comprehensive inspection, the lighting engineer must be very aware of all the conditions of the equipment and the environment. If there is something, please handle it in time so that you can have sufficient safety while obtaining a good visual environment. Protection.
Lamp position adjustment: Because some lamp position shifts or guest area changes during use will cause the lamp position to change, so the same position adjustment must be performed every month, including computer lights controlled by DMX512 signal.
Mechanical equipment testing: including motors for scanner lights, motors for color changers, nozzles of equipment and so on.
Check all lines: detect if there are breakpoints, breakage, or leakage, because in use, some human factors will inevitably cause various accidents to the line, such as the exposed wire being stepped on, frequently plugged or unplugged Breakpoints, occasional leakage or even short circuits due to sprinkled beverage lines, so this test should be done very carefully. This test requires weak current to cooperate.
Clean up the dust and garbage inside and outside the lamp. In use, the light itself will have some garbage, such as the garbage left in the lamp body by the explosion of the bulb, and the computer lights and machinery exposed to the audience area for a long time will easily fall into some garbage, such as ribbons, glass goblets, and beverages Fluid and so on. Uspješnost scenskog programa potkrepljuje i zvuk opreme za scensku rasvjetu, the garbage and dirt on the outside of the lamp must be wiped clean, and the garbage on the inside of the lamp must be cleaned.
Check all fire protection equipment. Light and sound are a relatively concentrated type of work in the circuit, strong electricity goes in and out of weak electricity, there are many related equipment and more related wires, so fire prevention is the top priority in lighting work. In monthly routine inspections, you should contact The security department cooperates to conduct a comprehensive inspection of all fire prevention facilities and fire extinguishing equipment. The monitoring scope includes the normality of fire prevention equipment, whether the choice of fire extinguishing equipment is normal, whether it is within the warranty period, and so on.


Ako je bežični mikrofon nestabilan: 2020-04-03
UPITITE ODMAH